Front; Remote Control Battery Installation; Remote Control Operating Range - Sanyo PLC-XU100 Owner's Manual

Remote Control Battery Installation

Open the battery
1
compartment lid.
To insure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.

Remote Control Operating Range

Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4' (5 m)
and 60 degrees in front of the projector.
Install new batteries into
2
the compartment.
Two AA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with
compartment.
Part Names and Functions
Replace the
3
compartment lid.
pins in the
16.4'
(5 m)
60°
Remote control
13