Leveling The Range; Instructions - GE Appliances JGB850 Owner's Manual And Installation Instructions

Installation Instructions
rs] ADJUST BROIL AND OVEN BURNER
AIR ADJUSTMENT SHUTTERS IF
NECESSARY (CONT.)
Oven bottom
To remove the oven bottom:
A. Remove the screws holding down the rear of the oven
bottom.
B. Grasp the oven bottom at finger slots on each side.
C. Lift the rear of the oven bottom enough to clear the
lip of the range frame, push it back, and then pull it up
and out.
@ LEVELING THE RANGE
A. Install the oven racks in the oven and check for
levelness before positioning the range where it will
be installed with front access to front leveling legs
and rear access to rear leveling legs. All legs must be
leveled before the product is installed.
Leg iang?
(on some models)
B. Check for levelness by placing a spirit level or a cup,
partially filled with water, on one of the oven racks.
If using a spirit level, take two readings-with the level
placed diagonally first in one direction and then the
other.
C. The front leveling legs can be adjusted from the bottom
through the front of the unit. The rear legs can be
adjusted from the bottom through the side of the unit.
D. Use an open-end or adjustable wrench to adjust the
leveling legs until the range is level.
IAWARN ING1
the leveling leg as the range will not be secured to the
anti-tip device properly.
E.After leveling the unit, slide it into final position and
verify levelness.
F. After the range is level, slide the range away from the
wall so that the Anti-Tip device can be installed.
[] INSTALLING THE ANTI-TIP DEVICE
A, WARNING
ANTI-TIP DEVICE
• All ranges can tip.
, BURNSor other SERIOUSINJURIES
cen result.
, INSTALLend CHECKthe
enti-tip brecket following the
instructions supplied with the bracket.
To reduce the risk of tipping the range, the range must
be secured by a properly installed anti-tip bracket. Follow
the instructions packaged with the bracket.
To check if the brocket is instolled end engoged
properly, look underneoth the ronge to see that the
rear leveling leg is engaged in the bracket. On some
models, the storoge drawer or kick ponel can be
removed for easy inspection. If visual inspection is not
possible, slide the range forward, confirm the anti-tip
bracket is securely attached to the floor or wall, and
slide the range back so the rear leveling leg is under
the anti-tip bracket.
If the range is pulled from the wall for any reason, always
repeat this procedure to verify the range is properly
secured by the anti-tip bracket.
If your range has no anti-tip bracket, call 1.800.626.8774
to receive one at no cost.
WHEN ALL HOOKUPS ARE COMPLETED
Hoke sure all controls ore left in the off position. Hake
sure the flow of combustion and ventilation air to the
range is unobstructed.
48