Table of Contents
Advertisement
Available languages
Available languages
Using the self-cleaning upper and lower ovens.
Theoven door must:be closed and all controls set correctly for the cycle to work properly.
GEAppliances.com
Wipe up heavy soil on the oven
bottom.
DO hand clean
DO NOT hand
inside door frame
clean gasket,
and glass.
DO hand clean oven frame.
Before a Clean Cycle
Forthe first self-clean cycle, we recommend
venting your kitchen with an open window
or using a ventilation fan or hood.
Remove any broiler pan, broiler grid, all
cookware, probe and any aluminum foil
from the oven-they cannot withstand the high
cleaning temperatures.
NOTE:
If your oven is equipped with nickel
oven racks, remove them before you begin
the self-clean cycle.
If your oven is equipped with gray porcelain-
coated oven racks, they may be left in the
oven during the self-clean cycle.
Soil on the front frame of the range and
outside the gasket on the front frame will
need to be cleaned by hand. Clean these
areas with hot water, soap-filled scouring
pads or cleansers such as Soft ScrubQ. Rinse
well with clean water and dry. Wipe off
the flat inner door with soapy water and a
sponge.
Do not clean the gasket. The fiberglass
material of the front frame gasket cannot
withstand abrasion. It is essential for the gasket
to remain intact. If you notice it becoming worn
or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Hake sure the oven light bulb cover is in place
and the oven light isoff.
IMPORTANT'. T he health of some birds
is extremely sensitive to the fumes given
off during the self-cleaning cycle of any range.
Hove birds to another well-ventilated room.
NOTE: Use caution when opening the upper
and lower oven after the self-clean cycle has
ended. Theoven may still be hot.
i
START
J
NOTES:
The surface burners must
be turened off prior to the
self-clean start time
Both ovens cannot be self-
cleaned at the same time.
Cooktop burners and the oven
not in self-clean mode will not
start during self-clean cycle.
How
to Set the Upper
Oven
for Cleaning
The oven door must be closed and all controls
set correctly for the cycle to work.
[]
Rotate upper oven knob to self-clean
position.
[]
Touch the Start pad.
Doors will lock automatically. The display will
show the clean time remaining. If the upper
door is not locked end remaining clean time
is not displayed, within 1 minute of initiating
the cycle rotate the knob to the Off positioin
and open both doors for 10 minutes. Repeat
step 1. Itwill not be possible to open the oven
door until the temperature
drops below the
lock temperature
and the LOCKED DOOR light
goes off.
The oven shuts off automatically when the
clean cycle is complete.
r_
When the LOCKEDDOOR light is off, the
door will unlock automatically.
r_
Rotate knob to the off position
The words LOCKDOOR will flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door.
To stop a clean cycle, touch the Clear/Off
pad then turn the oven control knob to the
OFF position. After some period of time, the
LOCKEDDOOR light will go off. This will
indicate that the oven has cooled below
the locking temperature and gas is able to
flow to the cooktop. The doors will unlock
automatically.
After you complete the first oven clean cycle,
you can start the second oven clean cycle.
27
Advertisement
Table of Contents
