Self-Cleaning - GE Appliances JGB850 Owner's Manual And Installation Instructions

Using the self-cleaning upper and lower ovens.
The oven door must be closed and all controls set correctly for the cycle to work properly.
SELF
CLEA
START
NOTES:
The surface burners must
be turened off prior to the
self-clean start time
Both ovens cannot be self-
cleaned at the same time.
Cooktop burners and the oven
not in self-clean mode will not
start during self-clean cycle.
How to Set the Lower Oven for Cleaning
[] Touch the Self Clean pad.
r_ using the number pads, enter the desired
clean time, if a time other than 4 hours is
needed.
Clean cycle time is normally 4 hours. You can
change the clean time to any time between
3 hours and S hours, depending on how dirty
your oven is.
[-_ Touch the Start pad.
Doors will lock automatically. The display will
show the clean time remaining. If the upper
door is not locked and remaining clean time
is not displayed, within 1 minute of initiating
the cycle rotate the knob to the Off positioin
and open both doors for 10 minutes. Repeat
step 1. It will not be possible to open the oven
door until the temperature drops below the
lock temperature and the LOCKEDDOOR light
goes off.
The oven shuts off automatically when the
clean cycle is complete.
r_ When the LOCKEDDOOR light isoff, the
door will unlock automatically.
[] Rotate knob to the off position
The words LOCKDOOR will flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door.
To stop a clean cycle, touch the Clear/Off
pad then turn the oven control knob to the
OFF position. After some period of time, the
LOCKEDDOOR light will go off. This will
indicate that the oven has cooled below
the locking temperature and gas is able to
flow to the cooktop. The doors will unlock
automatically..
After you complete the first oven clean cycle
you can start the second oven clean cycle.
W CSELF
LEAN
DFqDUo
E3 N
r-qrqDUoD
I START
How to Delay the Start of Cleaning (lower oven only)
Hake sure the clock shows the correct time
of day.
[71 Touch the Self Clean pad.
NOTE:Thesurface burners will be turned off
automatically when self-cleancycle starts.
[] Using the number pads, enter the desired
clean time.
[] Touch the Delay Start pad. The earliest
start time you can set will appear in the
display.
[] Using the number pads, enter the time of
day you want the clean cycle to start.
Touch the Start pad.
Doors will lock automatically. The display will
show the start time. It will not be possible to
open the oven door until the temperature drops
below the lock temperature and the LOCKED
DOOR light goes off.
The oven shuts off automatically when the
clean cycle is complete.
r_ The doors will unlock automatically.
The words LOCKDOORwill flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door.
To stop a clean cycle, touch the Clear/Off
pad. After some period of time, the LOCKED
DOOR light will go off. This will indicate
that the oven has cooled below the locking
temperature and gas is able to flow to the
cooktop. The doors will unlock automatically.
28
After a Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.
If white spots remain, remove them with a
soap-filled scouring pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
You cannot set the oven for cooking until the
oven is cool enough for the door to unlock.
While the oven is self-cleaning, you can
touch the Clock pad to display the time of
day. To return to the clean countdown, touch
the Cooking Time pad.
If the racks become hard to slide,apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
racks with the paper towel.