Touch Pad Models - GE Appliances AG_18 Owner's Manual And Installation Instructions

About the controlson the air conditioner-models with touchpads.
Features and appearance will vary.
- TEMP+
FAN SPEED
TIMER MODE
CJRCULAiRE
Air ConditionerControls
Remote Control
Controls
o ON/OFFPad
Ttnns air (onditioner on and ()ft_
Display
Shows the set temperature or time remaining
on timer.
O MODE
Use to set tile air (ondifioner to COOL or
FANmode.
Increase •/Decrease • Pads
Use to set temperature when in COOL mode.
O FANPad
Use to set the fan speed to LOW(F1),MED (P2)
or HIGH(F3!.
O IRCULAIRE
For continuous side-to-side _tircirculation
(cool settings only), set the ( irculaire s_dt(:h
to ON.
TIMER Pad
ON-When the air (onditioner is off, it can be
set to automatically come on in l to 12 houI's
at its previous setting. Each touch will set tile
time_ in horns.
OFF-When the air conditioner is on, it can be
set to mltomafically turn off in 1 to 12 h{nns.
Each touch will set the timer in hours. After
the timer has been on fin 30 minutes, the
tempex'aune will mlmmafically rise 2°F, and
after another 30 minutes, it will mltomatically
rise 2 °F again. The temperaUne will then st W
the same until the timer goes OFF.
To cancel the timer, press the TIMERpad
until the display time disappears.
O Remote Control Signal Receiver
For fixed side-to-side air direction, set the
Circulaire switch to ONuntil the desired air
direction is obtained, then move it to OFF.
4
Remote Control
i_:To ensure proper operation, aim the
remote conuol at the signal receiver
on the air conditioner.
i_:The remote control signal has a range ofup
to 21 feet.
i_ _Make sure nothing is between the air
conditioner and
the remote
(:ontiol
that (ould blo(k tile signal.
i_ _Make suie batteries are fiesh and installed
_orre_ tly-see the Care and Cleaningsection.