Touch Pad Models - GE AGM10 Owner's Manual And Installation Instructions

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
Cool o n
Fanon
Energy
Saver OR
orgy
on
Cool on
Air ConditionerControls
RemoteControl
Controls
ON/OFF Pad
TtlYns air conditionei" on and o_'.
Oisplav
Shows the set temperature or time remaining
on tiIlleI:
MODE
Use to set the air conditioner to
COOL
or
FANnlode.
Increase •/Decrease • Pads
Use to set temperatm'e when in COOL mode.
O FAN Pad
Llse to set the tm_ speed to LOW(FI),MED (F2)
or HIGH(F3).
ENERGYSAVER (on some models)
Controls the tim.
ON--The tim and compressor cycle on and
off. This results in wider variations of room
temperatm'e and humidit,i. Nommlly used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off
OFF--The tim runs all the time, while the
COIIlI)I'eSSOI" cycles
on _lll(l OIC[ ',
This teature must be set at OFFin order to
use the tim settim,s (on the mode control).
Note: On some models,the ENERGY SAVER
feature cannot be set on the air conditioner.
It must be set
using
the remote control.
CIRCULAIRE(on some models)
For contimu)us side-to-side air circulation
(cool settings only), set the Circulaire switch
to ON.
For fixed side-to-side air direction, tm'n
ON
tmtil the desired air direction is obt;fined,
then tm'n it
OFF.
@
TIMER Pad
ON--_]mn the air conditioner is off, it can be
set to automatically come on in 1 to 12 hom_
at its previous setting. Each touch will set the
timer in hom_.
OFF--_Aqmn the air conditioner is on, it can
be set to automatically mm off in 1 to 12
hom_. Each touch will set the timer in hom_.
O
To cancel the timer, press the TIMER pad until
the display time disappears.
Remote Control Signal Receiver
4
Remote Control
!i_:To ensm'e proper operation, aim the
remote control at the signal receixer
on the air conditione_:
!;?:The remote control signal has a range
of up to 21 feet.
_: Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
_: Make sure batteries are fl'esh and installed
correcflv as indicated on the remote control.