Reversing The Door Swing - GE Spacemaker DSXH43 Owner's Manual And Installation Instructions

Stacking Instructions-Reversing Door Swing
Thenumbers in the illustration correspond to steps.
5. Using the blade end ofa putb' knite co',ered with
masking tape, carefllll) remoxe .... the hole I_lugs, located
in the 1)otmm of the (h-vet fl'ont panel.
6,
7.
Remoxe the 4 legs from the dr}er base.
Place the dryer on top of the washe_: Slide the dr}er
back into the rear brackets (7A) then drop the fl'ont
down oxer the ti'ont brackets
(7B).
®
8. Insert the 2 long screws provided in the kit through
the holes in the dryer ti'ont panel and install into the
fl'ont mounting brackets.
9. Install the hole i)lugs removed in step 5.
10. Refer to the washer and dryer installation instructions
fin" proper installation and fimction.
11. Save the top panel and brackets in the case offlmu'e
side-by-side rise.
\\
REVERSING THE DRYER
DOOR SWING
1. Open the d_'er doo_: Remove the 4 hinge hole phlgs or
screws fl'om the left side of door opening. Place nearby
fl)r fllture installation. NOTE: You may need a plastic knife
to help pull out the plugs. Be careful not to scratch the paint.
2. Remove the fimr screws that secure the door hinges to
the dryer fl'ont panel. NOTE: Remove l screw from each
of the 2 hinges first. Hold the door firmly before removing the
last 2 screws.
3. Rotate the door 180 ° and reinstall
the door hinges
to the
(h?'er tixmt panel with the 4 screws.
4. Install the 4 hinge hole i)lugs or scre_:s that were
removed in stop 1 into the open screw holes on the right
side of the door opening.
Remove 4screws one from
2O