Table of Contents
Advertisement
ROUGH-IN DIMENSIONS
ELECTRIC CONNECTION
3/8" (0.96 cm) DIA.
GAS PIPE
REAR VIEW
OPTIONAL
VENT KNOCKOUT
SIDE VIEW
UNPACKING
1. Using the four shipping carton corner posts (two on each
side), carefully lay the dryer on its left side and remove foam
shipping base.
To prevent damage, do not use the control
panel or coin meter housing as a means to pick up or move the
dryer.
On under counter model clothes dryers, the top panel
may be removed for installation.
2. Return the dryer to an upright position.
REVERSING DOOR SWING
Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.
1. Open the dryer door. Remove the four hinge hole plugs from
the left side of the door opening. Place nearby for future
installation.
: You may need a plastic knife to help pull
out the plugs. Be careful not to scratch the paint.
2. Remove the four screws that secure the door hinges to the
dryer front panel (see below).
from each of the two hinges first. Hold the door firmly before
removing the last two screws.
3. Rotate the door 180° and reinstall the door hinges to the
dryer front panel with the four screws.
4. Install the four hinge hole plugs in the open screw holes on
the right side of the door opening.
5
FOAM
SHIPPING
PACKING
Remove one screw
REMOVE 4 SCREWS
(ONE FROM EACH
HINGE FIRST)
Advertisement
Table of Contents
