Adjusting Tool Rest
To position the tool rest assembly along the
length of the lathe bed:
1.
Figure 20.
2.
Note: The large clamping hex nut underneath
the tool rest base will require occasional
adjusting to ensure proper clamping pressure
of the tool rest assembly to the bed. Turn this
hex nut in small increments to fine tune the
clamping pressure as needed.
Always operate the lathe with the tool
rest assembly firmly locked in position.
Otherwise, serious personal injury may
occur.
To adjust the angle or height of the tool rest:
1.
2.
Figure 20
3.
21
Figure 21.
Figure