Troubleshooting - Marantz SA-KI-PEARL-LITE User Manual

Troubleshooting

If a problem occurs, first check the following:
1. Are the connections correct?
2. Is the unit being operated as described in the owner's manual?
If this unit does not operate properly, check the items listed in the table below. If the problem persist there
may be a malfunction.
In this case, disconnect the power immediately and contact the retail outlet.
Problem Cause
The disc fails to rotate. • The power cord is pulled out of
the socket.
• Power to this unit is not ON.
• The disc is not placed in the
correct position on the disc
tray.
• The disc is placed in upside
down. (The disc is placed in
with the label facing down).
The disc stops rotating • The disc is dirty.
in mid-operation.
• The disc is scratched.
• The disc is warped.
The disc is rotating but • The amplifier and speakers are
no sound is heard. not connected correctly.
• The amplifier power is not ON. • Turn ON the power to the
• The amplifier's function or
selector switch is not set to
"CD" or "AUX" or such (to
whatever you have connected
this unit to).
• The amplifier's volume control
is set at the minimum level.
Corrective action Page
• Insert the power cord plug 7
into the socket.
• Turn the power to this unit 8
ON.
• Place the disc in the disc tray 3
correctly.
• Place the disc in the disc tray 3
correctly.
• Clean the disc's surface. 4
• The disc may be unable to –
be played if it has a lot of
scratches.
• The disc may be unable to be –
played if it is badly warped.
• Connect the cables correctly. 7
(See the instruction manual
for the amplifier.)
–
amplifier.
(See the instruction manual
for the amplifier.)
• Switch the amplifier's –
function or selector switch
to "CD" or "AUX" or such
(to whatever you have
connected this unit to).
(See the instruction manual
for the amplifier.)
• Adjust the amplifier volume. –
(See the instruction manual
for the amplifier.)
Problem Cause
Remote control • The distance between this unit
operation is not and the remote control is too
possible. great.
• There is an obstacle between
this unit and
control.
• The remote control's batteries
are dead.
• A strong light is hitting the
unit's sensor window.
• The switch on the back of the
REMOTE CONTROL is on
EXTERNAL.
CD-R/CD-RW disc • The disc is placed in upside
cannot be played. down.
• The information recorded is
not in an audio (CD-DA) format.
Or the MP3/WMA file was not
properly recorded.
Cannot switch the • Start Sound Mode is set to CD. • Change Start Sound Mode
sound mode of an SA-
CD hybrid layer disc.
Sound is too quiet when • The PC volume is turned down. • Turn the PC volume up.
signals are output from
a PC.
ENGLISH
Corrective action
• Move closer to this unit, and
operate the remote control
within the operating range.
• Remove the obstacle.
the remote
• Replace all batteries with
new ones.
• Do not let strong light hit the
sensor window.
• When using this unit
independently, set the switch
to INTERNAL.
• Place the disc in the tray
correctly.
• Record correct information
that is compatible with to this
unit.
setting to Super Audio CD.
Page
4
4
4
4
14
3
14
20
18
24 24