Kenwood NEXEDGE NX-700 series Instruction Manual page 4

One or more of the following statements may be applicable:
FCC WARNING
Ths equpment generates or uses rado frequency energy. Changes or modfcatons to ths
equpment may cause harmful nterference unless the modfcatons are expressly approved n the
nstructon manual. The user could lose the authorty to operate ths equpment f an unauthorzed
change or modfcaton s made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC
Ths equpment has been tested and found to comply wth the lmts for a Class B dgtal devce,
pursuant to Part 15 of the FCC Rules. These lmts are desgned to provde reasonable protecton
aganst harmful nterference n a resdental nstallaton.
Ths equpment generates, uses and can generate rado frequency energy and, f not nstalled and
used n accordance wth the nstructons, may cause harmful nterference to rado communcatons.
However, there s no guarantee that the nterference wll not occur n a partcular nstallaton. If
ths equpment does cause harmful nterference to rado or televson recepton, whch can be
determned by turnng the equpment off and on, the user s encouraged to try to correct the
nterference by one or more of the followng measures:
•
Reorent or relocate the recevng antenna.
•
Increase the separaton between the equpment and recever.
•
Connect the equpment to an outlet on a crcut dfferent from that to whch the recever s
connected.
•
Consult the dealer for techncal assstance.
P
reCauTions
Observe the followng precautons to prevent fre, personal njury, and transcever
damage.
• Do not attempt to confgure the transcever whle drvng; t s too dangerous.
• Do not dsassemble or modfy the transcever for any reason.
• Do not expose the transcever to long perods of drect sunlght, nor place t near heatng
applances.
• If an abnormal odor or smoke s detected comng from the transcever, swtch the
transcever power off mmedately, and contact your Kenwood dealer.
• Use of the transcever whle you are drvng may be aganst traffc laws. Please check
and observe the vehcle regulatons n your area.
• Do not use optons not specfed by Kenwood.
◆ The transcever operates n 12 V negatve ground systems only! Check the battery polarty and
voltage of the vehcle before nstallng the transcever.
◆ Use only a Kenwood optonal DC power cable.
◆ Do not cut and/or remove the fuse holder on the DC power cable.
For passenger safety, nstall the transcever securely usng an optonal mountng bracket and screw
set so the transcever wll not break loose n the event of a collson.