Illumination Time For Ac Adaptor Operation; Illumination Time For Battery Operation; Temperature Display Unit - La Crosse Technology WS-2510 Operating Instructions Manual

Illumination time for AC adaptor operation

The illumination time for AC adaptor operation ("line") is displayed in the "LIGHT" field (touch screen field 1). A setting
here is only meaningful when the weather station is powered by means of the AC adaptor power supply.
The time displayed shows in hours and minutes how long the display is to remain lit after the last touch screen field has
been pressed.
A value of 0:00 means that the illumination will never come on.
A value of -:-- (appears after 9:59) means that the illumination will stay on continuously until it is turned off manually
("LIGHT OFF" in the main display).
- Touch screen field 1 must be pressed in order to set the required ON time.
- The associated display will now flash:
and the lower touch screen field will change to the following form:
- The required value between 0:00 and 9:59 as well as "-:--" can now be set using the touch screen fields "+" and "–".It
is possible to run through the display more quickly by pressing the relevant touch screen field for longer.
- When the required value has been set, you can exit set-up by pressing the "END" key. The value is now stored.

Illumination time for battery operation

The illumination time for battery operation ("batt") is displayed in the "LIGHT" field (touch screen field 2). A setting here is
only meaningful when the weather station is powered exclusively by batteries.
The time displayed shows in seconds (up to 99) how long the display is to remain lit after the last touch screen field has
been pressed.
A value of 0 means that the illumination will never come on.
- Touch screen field 2 must be pressed in order to set the required ON time.
- The associated display will now flash:
and the lower touch screen field will change to the following form:
- The required value between 0 and 99 seconds can now be set using the touch screen fields "+" and "–". It is possible
to run through the display more quickly by pressing for longer.
- When the required value has been set, you can exit set-up by pressing the "END" key. The value is now stored.
Setting the temperature display units
The display units for temperature are shown in touch screen field 4 at the top right.
The factory setting is ºF.
- By touching field 4 the display units can be switched between ºF and ºC.
11