Troubleshooting - La Crosse Technology WS-8318U Instruction Manual

2) Place the mounting bracket over the desired location. Through the three screw holes
of the bracket, mark the mounting surface with a pencil.
3) Where marked, start the provided screws into the mounting surface.
4) Screw mounting bracket onto the mounting surface. Ensure that the screws are flush
with the bracket.
MOUNTING WITH ADHESIVE TAPE
Mounting Bracket
Note: Adhesive tape should only be used temporarily while acquiring signal reception from
the atomic clock. The adhesive tape is not a permanent mounting solution.

TROUBLESHOOTING

Problem: The LCD is faint.
1) Replace the batteries.
Solution:
No reception of WWVB signal
Problem:
Solution: 1) It may help reception to face the front or back of the radio-controlled
2) Wait overnight for signal.
3) Be sure the radio-controlled clock is at least 6 feet (2 meters) from
4) Remove batteries for 15 minutes. See Setting-up.
Hour is incorrect (minute and date are correct).
Problem:
1) With a nonabrasive solution, clean and dry the back of the
mounting bracket and the mounting surface to ensure a
secure hold. The mounting surface should be smooth and
flat.
2) Remove the protective strip from one side of the tape.
Adhere the tape to the middle of the backside of the
mounting bracket
3) Remove the protective strip from the other side of the
tape. Position the outdoor temperature transmitter in the
desired location, ensuring that the radio-controlled clock
can receive the signal.
clock in the general direction of Ft. Collins, Colorado.
any electrical devices, i.e. TV sets, computers, or other radio
controlled clocks.
15