Table of Contents
Advertisement
Table 1:
Drive specifications
Drive specification
Standby/Sleep mode (typical)
Voltage tolerance (including noise)
Ambient temperature
Temperature gradient
(°C per hour max)
Relative humidity
Relative humidity gradient
Wet bulb temperature
(°C max)
Altitude, operating
Altitude, nonoperating
(meters below mean sea level, max)
Shock, operating (Gs max at 2ms)
Shock, nonoperating (Gs max at 2ms)
Shock, nonoperating (Gs max at 1ms)
Shock, nonoperating (Gs max at 0.5ms)
Vibration, operating (Swept Sine)
Vibration, nonoperating
Drive acoustics, sound power (bels)
Idle**
Seek
Nonrecoverable read errors
Annualized Failure Rate (AFR)
Load/Unload (U/UL) cycles
25°C, 50% relative humidity
32°C, 80% relative humidity
5°C, 80% relative humidity
5°C, 10% relative humidity
55°C, 16% relative humidity
Warranty
Supports Hotplug operation per Serial ATA
Revision 2.6 specification
*One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment
and formatting.
**During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and
power to operational levels.
***Typical notebooks will pull power to the drive when entering S3 and S4; while in the S3 and S4 states, drive sleep and drive standby
modes will not contribute to battery power consumption.
Momentus Thin Product Manual, Rev. E
ST320LT020 - 9YG142
0.15W ***
+5V ± 10%
0° to 60°C (operating), –40° to 70°C (nonoperating)
20°C (operating)
35°C (nonoperating)
5% to 95% (operating)
5% to 95% (nonoperating)
30% per hour max
37.7 (operating)
40 (nonoperating)
–304.8 m to 3,048 m (–1000 ft. to 10,000
–304.8 m to 12,192 m (–1000 ft. to 40,000
350
800
1000
600
1.0 Gs (0 to peak, 5–500 Hz)
5.0 Gs (0 to peak, 5–500 Hz)
2.0 (typical)
2.2 (max)
2.2 (typical)
2.4 (max)
14
1 per 10
bits read
0.48%
600,000 software-controlled power on/off cycles
20,000 hard power on/off cycles
600,000 software-controlled power on/off cycles
20,000 hard power on/off cycles
To determine the warranty for a specific drive, use a web browser to access the following
web page:
http://www.seagate.com/www/en-us/support/warranty_&_returns_assistance
You will be asked to provide the drive serial number, model number (or part number)
and country of purchase. After submitting this information, the system will display the
warranty information for your drive.
Yes (requires COMRESET from host after a hotplug event)
ST250LT003 - 9YG14C
+
ft.)
+
ft.)
ST160LT003 - 9YG141
5
Advertisement
Table of Contents
