Hex Dump Mode - SATO /s8408 Operator's Manual

HEX DUMP MODE

The contents of the print buffer and the data received before it is placed into the print buffer may be examined
through the use of the Hex Dump Mode. Each line of the printed data is enumerated in the first column, the second
column contains the data in hexadecimal format, and the right column contains the same data in ASCII format.
The options are: receive data, receive buffer, internal data, and send back data. However, only one type of data
may be printed on a single label. Repeat the hex dump process to print the other data types as desired. You cannot
enter the Hex Dump Mode when a print item exists.
The following four types of data are available for Hex Dump printing.
• Data received after setting Hex Dump Mode.
• Data (for one item) received before setting Hex Dump Mode.
• Data registered in internal buffer.
• Returning received data, which is a single item.
Use the buttons on the printer's operator panel to select and enter the required options. Refer to the Menu
Definition Tables in this chapter for an explanation of each menu screen.
S8400 Series Operator Manual
Unit 4: Printer Configuration
POWER
ONLINE
QTY: 000000
LINE
OFFLINE
QTY: 000000
ENTER
LINE
5 sec.
Cancels
CANCEL
print job
ONLINE MODE
CF Card User
Mode Mode
SEMBL MODE
Service
Mode
ADVANCED MODE
Figure 4-20, Hex Dump Mode
HEX DUMP MODE
Service
Interface
Mode
ENTER
PASSWORD
if password
0000
SELECT DUMP DATA
RECEIVE DATA
RECEIVE BUFFER
INTERNAL DATA
SEND BACK DATA
Internal Data Receive Data Receive Buffer
ENTER ENTER ENTER
HEX DUMP
NORMAL HALF
For For
Internal Data Receive Data
LINE
ONLINE
Hex
Dump is
printed
4-22
Mode
Displayed
feature is
enabled
Send Back Data
ENTER
PN: 9001160 (C)