Operating The D1500 With The D2500 Digital Eq; Using The D1500 With The D2500 - Samson D-150 Owner's Manual

Operating the D1500 with the D2500 Digital EQ

Using the D1500 with the D2500

In order for the D1500 and D2500 to communicate
with each other it is necessary to configure the MIDI
parameters so that the units are communicating
properly. Follow the steps below to configure the
MIDI parameters for communication between one
D1500 RTA and one D2500 Digital EQ. Let's start with
the D1500:
• Press the MIDI switch until you get to the "MIDI"
screen and use the DATA WHEEL to select "ON. "
NOTE: You may notice the MIDI light flashing which is
indicating that you are editing the MIDI set up.
• Now, press the MIDI again and set the MIDI
CHANNEL number to "1".
• Press the MIDI switch once again and use the DATA
WHEEL to set the "OMNI" mode to "OFF".
• Next, you need to configure the D1500 to trans-
mit and receive MIDI System Exclusive messages,
so press the MIDI switch again and use the DATA
WHEEL to set the SysEx to select "T+R".
• Press the MIDI switch once again and use the DATA
WHEEL to set the "Pgm Ch. " (MIDI Program Change)
to "OFF".
• Once you have all the parameters set, press the
STORE button to save the changes to the MIDI set
up.
The diagram above shows the MIDI connections for using a D1500 RTA with a D2500 .
���� ��
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES
CLASS B. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MUST NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
• Now, Let's set up the D2500.
• Press the D2500's Global switch a few times until
the display reads: F.R.
• Now, turn the Data Wheel until the dispay reads
+/-12 dB.
• Press the D2500's Global switch a few times until
the display reads: F.Bw.
• Then, turn the Data Wheel until the display reads
1/3 Oct.
• Press STORE to confirm the Global changes.
• Press the MIDI switch until you get to the "MIDI"
screen and use the DATA WHEEL to select "ON. "
NOTE: You may notice the MIDI light flashing which
is indicating that you are editing the MIDI set up.
• Now, press the MIDI again and set the MIDI
CHANNEL number to "1".
• Press the MIDI switch once again and use the DATA
WHEEL to set the "OMNI" mode to "OFF".
• Next, you need to configure the D1500 to trans-
mit and receive MIDI System Exclusive messages,
so press the MIDI switch again and use the DATA
WHEEL to set the SysEx to select "T+R".
• Press the MIDI switch once again and use the DATA
WHEEL to set the "Pgm Ch. " (MIDI Program Change)
to "OFF".
• Once you have all the parameters set, press the
STORE button to save the changes to the MIDI set
up.
���� ���
���� ��
�����
���� ���
�����
15