Operation - Ryobi RY24200 Operator's Manual

SETTING UP THE MITER SAW
The MS181 Miter Saw provided in the "Six Pack" has
been securely attached to the top lid. This convenient
mounting allows a quick and simple set up and stow
away procedure. These procedures are illustrated on
the top, front surface of the lid for easy reference.
See Figure 3.
Follow these directions to set up the miter saw.
Loosen each lid latch by pulling out on the bottom of
the latch, lifting the latch, and then lowering the top
of the latch. (1)
Stand in front of the case. (The case handle will be
on the left.)
Reach across the lid with your left hand, grasp the
right side handle, and raise the lid. (2)
Grasp the miter saw carrying handle with your right
hand. (3)
Rotate and lower the lid and saw assembly smoothly
into position, allowing the lid to sit squarely on the
base. (4 and 5)
Secure the lid latches. (6)
The MS181 Miter Saw is now ready for use on the "Six
Pack" work surface. Refer to the MS181 Operator's
Manual for safety rules and operation instruction. Release
the lock pin to raise the saw head. Make all necessary
set up and adjustments. When ready for the cut, insert a
battery and proceed safely.

OPERATION

7
1
2
3
4
5
6
Fig. 3