Adjustments - Ryobi JM80 Owner's Operating Manual

FENCE HEIGHT ADJUSTMENT
See Figure 5.
The adjustable fence on your plate joiner can be moved up
and down to adjust the position of the blade in relation to the
top of the workpiece. A scale on both sides of the fence
indicates the height of the fence from the center of the blade.
The fence can be positioned up to two inches from the center
of the blade. However, the scale and indicator point can only
be set up to 1-1/2 in. from the center of the blade. Scale
marks are in increments of 1/16 in.
TO ADJUST HEIGHT SETTING
See Figure 5.
1. Unplug your plate joiner.
WARNING:
Failure to unplug your plate joiner could result in
accidental starting causing possible serious personal
injury.
2. Loosen the two height adjustment knobs. NOTE: Loosen
each height adjustment knob approximately one turn.
3. Slide the fence up or down until the indicator point is
aligned with the desired dimension on the scale.
4. Tighten height adjustment knobs securely.
FENCE ANGLE ADJUSTMENT
See Figure 6.
The adjustable fence on your plate joiner can be set at angles
ranging from 0° to 135°, with quick, accurate positive stops
set in 45° increments. A scale is located on both sides of the
front handle for identifying these positive stop angles. Each
click you hear when rotating the adjustable fence from one
angle setting to another equals a 45° positive stop angle
change.
TO ADJUST ANGLE SETTING
See Figure 6.
1. Unplug your plate joiner.
WARNING:
Failure to unplug your plate joiner could result in
accidental starting causing possible serious personal
injury.
2. Loosen the two height adjustment knobs. NOTE: Loosen
each height adjustment knob approximately one turn.
3. Rotate adjustable fence up or down to the desired angle.
4. Tighten height adjustment knobs securely. See Figure
6.

ADJUSTMENTS

FRONT HANDLE /
ADJUSTMENT
ADJUSTABLE
SETTING SCALE
ADJUSTABLE
ROTATE ADJUSTABLE FENCE
TO DESIRED ANGLE SETTING
Page 10
FENCE
ADJUSTMENT KNOB(S)
TO LOWER
FENCE
ANGLE
TO RAISE
FENCE
TO
TIGHTEN
HEIGHT
HEIGHT
SETTING SCALE
INDICATOR
POINT
TO
LOOSEN
TO
TIGHTEN
Fig. 5
TO
LOOSEN
Fig. 6