Ryobi RY29550 Operator's Manual page 16

INSTALLINg STRINg IN REEL EASY STRINg
HEAD
See Figures 17 - 18.
Use .095 in. diameter monofilament string.
 Stop the engine and disconnect the spark plug wire.
 Cut one piece of string approximately 5 ft. in length.
 Rotate knob on string head until line on knob aligns with
arrows on top of string head.
 Insert one end of string into eyelet located on the side of
the string head and push until string comes out through
eyelet on the other side. Continue to push string through
the string head until the middle section of the string is
inside the string head and string outside the string head
is evenly divided on each side.
 Rotate the knob on the string head to wind the string. If
using the CS30, knob should be rotated counterclock-
wise. If using the SS30 or the BC30, knob should be
rotated clockwise. Wind the string until approximately
8 in. remains protruding from the string head.
MAINTENANcE
16 — English
ALIGn
LInE On
knOb wITH
ARROwS
Fig. 17
InSERT
STRInG TO
cEnTER
AnD ROTATE
knOb TO
wInD
EyELET
Fig. 18