Additional Connections To The Dimension Digital Controller (Optional) - Runco LightStyle LS-12d Installation & Operation Manual

The Dimension Digital Controller provides the following interfaces to external equipment
that allow it to control or be controlled by that equipment:
• An RS-232 interface to a PC or control/automation system;
• Three (3), 12-volt trigger outputs;
• An infrared (IR) repeater input;
• An Ethernet network interface for firmware updates and maintenance notifications.
The following sections describe how to make these interface connections.
RS-232 Controller Connection: Use a straight-through, 9-pin RS-232 cable to connect
a PC or control/automation system (if present) to the RS-232 port on the Dimension
Digital Controller; see Figure 3-11.
Pri. Display Control Pri. Display Control Sec. Display Control Sec. Display Control
IR IR
HDMI 5 HDMI 5 HDMI 7 HDMI 7 To Sec. Display To Sec. Display
HDMI 6 HDMI 6 HDMI 8 HDMI 8
Ethernet Ethernet
to Automation/
Control System
or PC
Figure 3-11. RS-232 Control System Connection to Dimension Digital Controller
LightStyle™ LS-12d Installation/Operation Manual
RS-232
PC / Control
HDMI Out HDMI Out
HDMI Out HDMI Out HDMI Out HDMI Out
Audio Only Audio Only To Pri. Display To Pri. Display
5 4 3 2 1
9 8 7 6
2 Receive Data
(to ctrl. system)
3 Transmit Data
(from ctrl. system)
5 Ground
(none of the other pins are used)
39
Installation
Additional Connections to
the Dimension Digital
Controller (Optional)