Blind Hemming - Janome Sewing Machine Instruction Book

q
w
z
q
(1)
x
c
(1)
t
w e
q
(2)
v
e
y
r
t
(2)
r

Blind Hemming

q Stitch pattern:
w Thread tension dial:
e Presser foot:
z Fold a hem with the wrong side of the fabric up to
w
form a 0.4 – 0.7 cm allowance.
q Wrong side of fabric
w 0.4 – 0.7 cm
(1) Fold the hem under the fabric for lightweight
fabrics.
(2) On heavyweight fabrics that tend to ravel, the
raw edge should be overcast first.
x Place the fabric so that the needle just pierces the
folded edge when the needle comes over the
extreme left side. Lower the presser foot.
c Turn the guide screw to adjust the position of the
guide to match it with the folded edge. Sew
guiding the folded edge along the guide.
e Guide screw
r Guide
t Folded edge
v Open the fabric after sewing is finished.
y Right side of the fabric
• Fine-tuning the needle drop position
The needle drop position can be adjusted by pressing
stitch width adjusting button.
(1) Press the minus (–) key to move the needle drop
position to the right.
(2) Press the plus (+) key to move the needle drop
position to the left.
r Guide
t
Left needle drop position
NOTE:
The needle drop position will move to the left or right,
but the stitch width is remained the same.
31
A
Blind hem foot: G