Changing Needles; To Attach And Remove The Presser Foot; To Remove And Attach The Foot Holder - Janome Memory Craft 4400 Instruction Book

z
q
c
z
q
z
q
14
x
w
e
x
e
w
x
w
e

Changing Needles

z
Raise the needle by pressing the Up/down needle
position key and lower the presser foot.
Turn off the power switch.
Loosen the needle clamp screw by turning it
counterclockwise.
Remove the needle from the clamp.
x
Insert the new needle into the needle clamp with the
flat side to the rear.
When inserting the needle into the clamp, push it up
as far as it will go. Tighten the clamp screw firmly by
turning it clockwise.
c
To check for a good needle, put the flat side of the
needle onto something flat (the needle plate, glass
etc.).
The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt needle.
q
Needle clamp screw
w
Pin
e
Needle clamp

To Attach and Remove the Presser Foot

z
Press the red button on the back of the foot holder.
The presser foot will drop off.
x
Place the selected presser foot so the pin on the foot
lies just under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
q
Red button
w
Groove
e
Pin

To Remove and Attach the Foot Holder

z
To Remove:
Remove the screw by turning the screw
counterclockwise with the screwdriver.
x
To Attach:
Match the hole in the foot holder with the threaded
hole in the presser bar.
Fit the screw into the hole.
Tighten the screw by turning it clockwise.
q Screw
w Foot holder
e Presser bar