iRobot Verro 600 Owner's Manual page 25

irobot
Quick Start
(cont...)
When Verro has finished cleaning the pool, it will stop automatically and the light
8
on the Power Supply will go OFF.
9
Wait 20 minutes before removing Verro from the pool to allow the motors to cool.
Shut off and unplug the Power Supply every time you remove the cleaner from
the water. Always remember to turn the Power Supply OFF and unplug it from
the power outlet before removing the cleaner from the pool.
10
Unplug the Power Supply from the GFCI outlet.
Never leave the Power Supply plugged in when Verro is not in use.
11
Unplug the floating power cord from the Power Supply.
Rotate counter-clockwise
and pull to unlock
© 2007 iRobot Corporation, 63 South Avenue, Burlington, MA 01803. All rights reserved. iRobot is a registered trademark and Verro is a trademark
of iRobot Corporation. Cover photo © Veer incorporated 2002 - 2005. All rights reserved.
Verro quick start guide
®
™
12
Use the floating power cord to pull Verro to the edge of the pool, and then use the
handle to lift Verro out of the water. Water will drain from Verro as it is lifted.
see Owner's Manual
for detailed product
instructions.
Visit
www.irobot.com/usetips
for instructional photos