Basic Operation; Turning On The Power; Channel Selection - Icom IC-F5010 series Instruction Manual

■ Turning ON the power

q Push [ ] to turn ON the power.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• The keys shown below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY P0
0
NUMBER
5
e If all channel indicator LEDs still blink after inputting 4 dig-
its, the input code number may be incorrect. Turn OFF the
power and re-enter your password.
P1 P2 P3
1 2 3 4
6 7 8 9

BASIC OPERATION

■ Channel selection

There are several methods to select channels, and they may
differ, according to your system set up.
Push [CH Up] or [CH Down] to sequentially select the desired
operating channel, or push one of the [MR-CH 1] to [MR-CH 4]
keys to select a channel directly.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turn-
ing ON power, the transceiver automatically starts scanning.
Scanning stops when a signal is detected.
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
7