Other Functions; I Smart-Ring And Ats (Automatic Transponder System) - Icom IC-41S Instruction Manual

Uhf c.r.s transceiver
Hide thumbs Also See for IC-41S:
Table of Contents

Advertisement

8

OTHER FUNCTIONS

I Smart-Ring and ATS
These functions have an answer back feature, and allow you
to confirmation of whether or not a call has reached the
receiving party even if the operator is temporarily away from
the transceiver. The Smart-Ring is for manual, and the ATS
is for automatic confirmation.
D Smart-Ring
q Set the same CTCSS tone frequency for all of the group
transceivers and turn the tone squelch ON. (pgs. 22, 34)
w Push [Top]
(Function)
to send the Smart-Ring call.
(S-Ring)
• "
" appears.
• When a member of a specific group answers a call, "ë" and
"FOUND" blink.
• When no answer back is received, the transceiver emits short
failure beep tones and "FAILD" appears.
Appears
e Push [PTT] to answer and to stop blinking.
NOTE: The Smart-Ring function is available only when the
called station has set the same CTCSS tone frequency
and the same operating channel as you.
30
(Automatic Transponder System)
to enter the function mode, then push
NOTE:
• The setting at left is for the calling station only. A called
party automatically sends an answer back signal without
any pre-settings. All IC-41S's operating on the same op-
erating channel will answer back to the call in the sur-
roundings communications area.
• When RX channel is selected, "N/A" appears.
D ATS
q Push [Top]
and hold [Side1]
• When RX channel is selected, error beep is emitted.
• The transceiver starts to send a searching signal every 60 sec.
• "
" appears and "
function is activated.
• When the transceiver receives an answer back signal, "
on the display until the next search transmit.
Blink
• If no reply is received, "
Appears
Blinks
w Push [Top]
and hold [Side1]
OFF.
to enter the function mode, then push
(Function)
for 2 sec. to turn the ATS function ON.
(ATS)
" starts blinking on the display when the
" blinks until the next search transmit.
If no reply is received
to enter the function mode, then push
(Function)
for 2 sec. to turn the ATS function
(ATS)
" stays
Blinks

Advertisement

Table of Contents
loading

Table of Contents