Husqvarna Automower solar hybrid Operator's Manual page 12

Working method
Automower automatically mows the lawn.
®
It continuously combines mowing and charging.
The charging station sends out a signal that
Automower can sense at a distance of 6 - 7 metres.
®
The mower starts to search for the charging station
when the battery charge becomes too low.
Automower ® does not mow when it is searching for
the charging station.
When Automower ® searches for the charging station
it uses one or more of three different search methods:
Irregular, Follow boundary wire and Follow guide
wire. For more information about the search
methods, see 2.3 Search method on page 15 and
Follow loop in (3-2-2) on page 50.
When the battery is charged the mower reverses,
turns around and leaves the charging station in a
randomly selected direction within the exit sector
90° - 270°.
To make it easier for Automower
the garden you can manually set how the mower will
leave the charging station, see 6.5 Installation (3) on
page 48.
When Automower body hits an obstacle, the mower
®
reverses and selects a new direction.
Two sensors, at the front and back on Automower
sense when the mower approaches the boundary
wire. Automower ® overruns the wire by up to
27 centimetres before it turns. The overrun length
can be set, see Drive past wire (3-4-2) on page 54.
The STOP button on the top back edge is mainly
used to stop the mower when it' s running. When the
STOPbutton is pressed down it is possible to open
the solar cell panel, under which there is a control
panel. The STOP button remains depressed until the
cover is reset again. This acts as start inhibitor.
2. PRESENTATION
to reach all parts of
®
,
®
English - 13