Vibration Damper - Jonsered 2036 Workshop Manual

A
B
A
B
A
B
Crankshaft and crankcase
Mod. 2036/2040
Remove the screws (A) and separate the
front handlebar from the rear handle. Fit a
new damper.
Remove the screw (B) and fit a new
damper.
C
Mod. 2041/2045/2050
Release the screw which holds the vibra-
C
tion damper to the cylinder.
Remove the screws (A) and (B) and then
lift off the complete handlebar section.
Remove the screws, separate the handle-
bar from the rear handle and replace the

vibration damper.

502 71 27-01
Mod. 2054/2055
Replace the screw which holds the vibra-
tion damper at the cylinder.
Release the screws (A) and (B) and pull
out the handlebar far enough so that the
respective dampers can be replaced.
504 90 00-02
Mod. 625/630/670
Dismantle the chain brake, chain, bar,
cylinder cover, air filter, the throttle lever's
push rod, the fuel pipe from the car-
burettor, and the earth cable's connection
screw.
Mod. 2036/2040
The vibration damper to the cylinder can
be replaced after the screws (A) have
been removed and the front handlebar
has been removed from the rear handle.
The vibration damper to the crankcase
can be dismantled and replaced when
the screw (B) inside the damper has been
removed.
NOTE!
The safety band (C) must without fail be
fitted when replacing the damper.
Mod. 2041/2045/2050
Release the screw which holds the vibra-
tion damper to the cylinder.
Remove the screws (A) and (B) and then
lift off the complete handle section.
All the vibration dampers are now easily
accessible for replacement.
Remove the screws and separate the
front handlebar from the rear handle. The
vibration damper to the cylinder can now
be replaced.
NOTE!
The safety band (C) must without fail be
fitted during replacement.
Mod. 2054/2055
Remove the screw which holds the vibra-
tion damper between the cylinder and the
handlebar.
Release the screws (A) and (B) and pull
out the handle section far enough so that
respective dampers can be replaced. The
rear damper is attached with a hex screw
inside the spring.
The vibration damper on the cylinder can
be released by using a pair of universal
pliers.
Mod. 625/630/670
Dismantle the chain brake, chain, bar,
cylinder cover, air filter, the throttle lever's
push rod, the fuel pipe from the carbu-
rettor, and the earth cable's connection
screw.
8
97