Lift Up Carburettor And Dismantle - Jonsered 2036 Workshop Manual

6
1
2
5
1
2
Fuel system
Lift up the carburettor and dismantle:
1. The screwdriver guide for the carbu-
rettor's adjusting screws.
2. The ventilation pipe from the nipple
on the fuel tank.
3. The carburettor screws.
4
4. The air filter connection.
5. The choke lever.
6. The throttle wire.
3
Dismantle the fuel pipe and impulse pipe.
Lift off the carburettor.
Fitting mod. 2054/2055
Fit the carburettor in the reverse order to
dismantling.
Make sure the throttle wire is connected
from the correct side.
502 50 87-01
Dismantling mod. 625/620/670
Dismantle the air filter and following parts:
1. The throttle control's push rod.
2. The impulse pipe.
3 3. The fuel pipe.
4. The choke lever.
4
Lift up the carburettor and dismantle:
1. The screwdriver guide for the carbu-
rettor's adjusting screws.
2. The ventilation pipe from the nipple
on the fuel tank.
3. The carburettor screws.
4. The air filter connection.
5. The choke lever.
6. The throttle wire.
Turn the carburettor and dismantle the
fuel pipe and impulse pipe.
The fuel pipe is provided with a wire spiral
to prevent it being bent and restricting the
fuel flow.
Tips!
Turn the spring clockwise so that it is
easier to move along the pipe.
Use a screwdriver to push the fuel pipe
away from the nipple.
Fitting mod. 2054/2055
Fit the carburettor in the reverse order to
dismantling.
Screw in the left-hand screw first. Use
screwdriver No. 502 50 87-01.
Angle up the carburettor with a screwdriver
and screw tight the right-hand screw.
NOTE!
● The throttle wire should be connected
to the lever from the inside and out.
Otherwise the choke lever will not
function satisfactorily.
● The pipe for the tank vent should lie
under the fuel pipe.
Dismantling mod. 625/630/670
Dismantle the air filter and following parts:
1. The throttle control's push rod (use a
screwdriver).
2. The impulse pipe.
3. The fuel pipe.
4. The choke lever (use a screwdriver).
4
41