Installation Considerations - Rockford Fosgate 2.3 Installation And Operation Manual

100 watt 2-channel amplifier 150/300 watt 2/4-channel amplifier with crossover
Table of Contents

Advertisement

I
N S TA L L AT I O N
The following is a list of tools you will need for installing the amplifier:
Wire Cutters
Wire Strippers
Wire Crimpers
Voltmeter
This section focuses on some of the vehicle considerations for
installing your new amplifier. Checking your battery and present
sound system, as well as pre-planning your system layout and best
wiring routes will save installation time. When deciding on the layout
of your new system, be sure that each component will be easily
accessible for making adjustments.
Before beginning any installation, be sure to follow these simple rules:
1. Be sure to carefully read and understand the instructions before
attempting to install the amplifier.
2. For safety, disconnect the negative lead from the battery prior to
beginning the installation.
3. For easier assembly, we suggest you run all wires prior to
mounting your amplifier in place.
4. Route all of the RCA cables close together and away from any high
current wires.
5. Use high quality connectors for a reliable installation and to
minimize signal or power loss.
6. Think before you drill! Be careful not to cut or drill into gas tanks,
fuel lines, brake or hydraulic lines, vacuum lines or electrical
wiring when working on any vehicle.
7. Never run wires underneath the vehicle. Running the wires inside
the vehicle provides the best protection.
8. Avoid running wires over or through sharp edges. Use rubber or
plastic grommets to protect any wires routed through metal,
especially the firewall.
9. ALWAYS protect the battery and electrical system from damage
with proper fusing. Install a fuseholder and appropriate fuse on
the +12V power wire within 18" (45.7 cm) of the battery terminal.
10. When grounding to the chassis of the vehicle, scrape all paint
from the metal to ensure a good, clean ground connection.
Grounding connections should be as short as possible and always
be connected to metal that is welded to the main body, or chassis,
of the vehicle.
C
O N S I D E R AT I O N S
#2 Phillips Screwdriver
Assorted wire connectors
Battery Post Wrench
Electric Hand Drill with assorted bits
– 7 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2.64.62.6x4.6x

Table of Contents