ASSEMBLY
TABLE EXTENSION
See Figure 9.
The table extension can be used on the left side of the miter
saw. To assemble and install the table extension:
Insert socket head screw and washer into the two holes
in the side of the miter saw base.
Tighten securely.
MITER LOCK HANDLE
See Figure 10.
To install the miter lock handle, place the threaded stud on
the end of the miter lock handle into the threaded hole in the
control arm under miter table. Turn clockwise to tighten.
DUST GUIDE
See Figure 11.
Insert the dust guide inside the exhaust port in the upper
blade guard. Turn the guide so that the open end is facing
down or toward the rear of the saw.
TABLE
EXTENSION
WASHER
SOCKET HEAD
SCREW
WASHER
Fig. 9
TO
TIGHTEN
MITER
LOCK
HANDLE
LOOSEN
UPPER
BLADE GUARD
DUST
GUIDE
EXHAUST
PORT
15
TO
CONTROL
ARM
Fig. 10
Fig. 11