HP Configuring Arrays Reference Manual page 62

•
[ssdrpt=on|off] specifies to generate or not generate the Smart SSD Wear Gauge report. The
default is off.
•
[xml=on|off] outputs diagnostic information in formatted XML. The off value is provided for
backward compatibility and is ignored.
•
[zip=on|off] compresses the output to a zipped file. Default behavior is uncompressed. The off
value is provided for backward compatibility and is ignored.
Example commands:
ctrl all diag file=c:\allcontrollers.zip
ctrl slot=4 diag file=c:\ctrl_slot4.zip
ctrl ch="mybox" diag file=mybox.zip ssdrpt=on
Erasing a physical or logical drive
Syntax:
<target> modify [erase
erasepattern=zero|random_zero|random_random_zero][deleteaftererase=yes|n
o]
where the target can be any valid physical drive or logical drive. The option to delete the target after erasing
it is no longer supported. Although [deleteaftererase=yes|no] can still be entered, it is valid only if
the target is a logical drive, and the logical drive will always be erased.
To stop an erase process at any time, enter the stoperase command.
Example commands:
=> ctrl slot=3 ld 2 modify erase erasepattern=zero
=> ctrl slot=4 ld all modify erase erasepattern=random_zero
=> ctrl slot=3 ld 2 modify stoperase
Rescanning the system
A rescan detects devices that have been added to the system since the previous rescan or since the ACU CLI
was started, whichever is more recent.
Syntax:
Use the word rescan directly at the ACU CLI prompt, without any target device or parameters.
Example command:
=> rescan
Entering or deleting a license key
Some advanced configuration tasks (available only on certain controller models) can be performed only after
software is installed on the controller and a license key is registered to activate the software.
Syntax:
<target> add [lk=xxxxx-xxxxx-xxxxx-xxxxx-xxxxx]
where the target is any valid controller. The hyphens are optional.
To delete a license key, use a standard delete command but use the license key (not the controller) as the
target:
<target> delete
Example commands:
=> ctrl slot=5 lk=12345-65432-78787-43434-24680 delete
HP Array Configuration Utility 62