Table of Contents
Advertisement
OPERATION
EMERGENCY STARTING
If the recoil starter is not working properly, the engine can be started with
the spare starter rope in the tool kit.
1. Remove the engine cover.
2. Remove the recoil starter by removing the three 5 mm nuts.
3. Follow steps 1 through 5 of the normal engine starting procedure (see
pages 25 and 26).
4. Wind the spare rope clockwise around the pulley, and then pull it
straight out to start the engine. Keep clear of moving parts.
5. Leave the recoil starter off and reinstall the engine cover.
Exposed moving parts can cause injury.
Use extreme care when installing the en-
gine cover. Do not operate the outboard
motor without the engine cover.
ENGINE COV
ARTER ROPE
28
Advertisement
Table of Contents
