Submerged Motor - Honda Marine BF2D Owner's Manual

TAKING CARE OF UNEXPECTED PROBLEMS

SUBMERGED MOTOR

A submerged outboard motor must
be serviced immediately after it is
recovered from the water in order to
minimize corrosion.
If there is a Honda Marine dealership
nearby, take the motor to the dealer
immediately. If you are far from a
dealer, proceed as follows:
1. Remove the engine cover, and
rinse the outboard motor with
fresh water to remove salt water,
sand, mud, etc.
2. Drain the carburetor as described
on p. 54 .
62
3. Change the engine oil as described
on p. 43 44 . If there was water
in the engine crankcase, or if the
used engine oil showed signs of
water contamination, then a second
engine oil change should be
performed after running the engine
for half an hour.
Direction to pull
STARTER GRIP
4. Remove the spark plug (p.
and remove the emergency stop
switch clip from the emergency
stop switch. Pull the starter grip,
rotate the flywheel a few
revolutions to completely expel
any water from the cylinder.
If the engine was running when it
submerged, there may be
mechanical damage, such as a bent
connecting rod. If the engine binds
when cranked, do not attempt to
run the engine until it has been
repaired.
47 ),