10. MAINTENANCE
Replacement
1. Stop the engine.
2. Remove the engine cover.
3. Pull the blown fuse out of the clip.
4. Push a new fuse into the clip.
Spare fuses are located in each
fuse holder. If the spare fuse is not
available, the motor will need to be
started with the pull starter rope
(refer to the emergency start procedure
page 69).
Propeller
THRUST
PROPELLER
If the propeller is damaged by striking a
rock, or other obstacle, replace the
propeller as follows.
-
l
When replacing,
remove
the
engine
switch
key to prevent
accidental
engine
starting.
l
The propeller
is thin and
sharp.
To protect
your hands,
wear
the heavy gloves
during
re-
placement.
PIN
Replacement
1. Remove the cotter pin then remove
the 18.5 mm castle nut, 19 mm plain
washer, propeller and thrust washer.
2. Install the new propeller in the reverse
sequence to removal. Be sure to
replace the cotter pin with new one.
NOTE:
l
Install the thrust washer with the
grooved side toward the gear case.
l
Use a genuine Honda cotter pin and
bend the pin ends as shown.
125