Table of Contents
Advertisement
3c.
Clearing in MANUAL mode
Nothing is controlled automatically when the mode selector
switch is set at the MANUAL position. Engine speed and operating
speed can be adjusted freely by selecting the MANUAL mode.
THROTTLE CONTROL LEVER
MANUAL mode
RESET SWITCH
N (neutral)
D
D
R
R
I
I
V
V
E
E
C
C
L
L
U
U
T
T
C
C
H
H
L
L
E
E
V
V
E
E
R
R
3rd
CHUTE CONTROL
SWITCH
AUGER HOUSING
CONTROL SWITCH
MAIN SHIFT LEVER
1)
Set the throttle control lever in the
third position from the bottom.
2)
Operate the chute control switch to
adjust the snow discharge direction
and angle (see page
3)
Operate the auger housing control
switch to adjust the auger to be
parallel to the road surface (see
pages
45
and
You can return the auger to the
initial height position by pushing
the reset switch.
If you return the auger to the
initial height position by pushing
the reset switch, the auger can hit
against the road surface or can be
raised from the road, resulting in
some snow left on the ground,
depending on the road condition
and the position of the
snowblower. Adjust the auger
height position as needed.
4)
Check that the main shift lever is in
the N (neutral) position and squeeze
the drive clutch lever.
OPERATION
25
).
47
).
55
Advertisement
Table of Contents
