Table of Contents
Advertisement
Adjust the skid equally on both sides.
Be sure to tighten the skid and scraper bolts securely after making
adjustment.
Do not use the snowblower on rough or uneven surfaces with the
auger ground clearance set for hard snow or surfaces.
This may cause serious damage to the snow blowing mechanism.
Adjust the skid and scraper in the following cases
When the auger interferes with the road surface while it is turning:
When clearing the snow from the graveled road:
Raise the auger approximately 0.5 in (12 mm) from the ground
and secure the skid in this position.
Secure the scraper by raising it 0.3 in (7 mm) from the ground.
Do not clear the snow thoroughly from the ground. Leave some
on the ground to prevent gravel and other foreign material being
caught in the auger.
To break down the hardened snow that dropped from the roof:
When the snow is too hard to dig in, making the snowblower rise
on the snow:
Raise the skid and scraper to the uppermost position of the
adjustment range with the auger in contact with the ground, and
secure the skid and scraper in position.
Raise to the uppermost
position.
Note that the road surface can be damaged and stones can be thrown
out of the auger if it comes in contact with the ground. Return the skid
and scraper to the original position when operating the snowblower
under normal conditions.
SKID
SCRAPER
0.3 in (7 mm) min.
SKID
SCRAPER
OPERATION
AUGER
Approx. 0.5 in (12 mm) min.
AUGER
43
Advertisement
Table of Contents
