Inputting Image From Main To Sub - Video Signal (Either Component Or Video); Inputting Image To Sub And Main Individually - Hitachi CP-X8150 User Manual

Inputting image from Main to Sub
- Video signal (either component or video)
1.
If the STACK menu is already displayed on the screen, proceed to 3 below.
Otherwise press the
If the MENU dialog is displayed, use the ▲/▼ buttons to highlight MAIN, and
press the ► button. A menu will be displayed.
If the MENU dialog is not displayed, the STACK menu will appear.
2.
Press the
or control panel on the Main projector. Use the
▲/▼/◄/► buttons to open the COMPUTER IN
dialog. ( Operating Guide
3.
To input component signals to
Then, use the ▲/▼/◄/► buttons to highlight EXIT and press the ► button to
complete the setting.
To input video signals to
is necessary to select a video format, use the ▲/▼/◄/► buttons to highlight
RETURN and press the ◄ button to display the INPUT menu. Otherwise, use
the ▲/▼/◄/► buttons to highlight EXIT and press the ► button to complete
the setting.
4.
Select VIDEO FORMAT in the INPUT
menu to display the VIDEO FORMAT
dialog.
Select AUTO or an appropriate format for
the video signal input.
Then, use the ▲/▼/◄/► buttons to highlight EXIT and press the ► button to
complete the setting.

Inputting image to Sub and Main individually

1.
If the STACK menu is already displayed on the screen, proceed to 3 below.
Otherwise press the
If the MENU dialog is displayed, use the ▲/▼ buttons to highlight MAIN, and
press the ► button. A menu will be displayed.
If the MENU dialog is not displayed, the STACK menu will appear.
2.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen.
( Operating Guide
(continued on next page)
button on the remote control.
button on the remote control
→ INPUT
button on the remote control.
→ OPTION menu)
Setting input ports using menu
menu)
or
or , set the port to VIDEO. If it
28
, set the port to AUTO.