Connection To The Video Signal Terminals; Connection To The Rgb Signal Terminals - Hitachi CP-X955 Operating Manual

Connection to the video signal terminals

1. Input signal
Luminance signal
S-VIDEO signal
Chrominance signal
VIDEO signal
Input
AUDIO signal
Output
2. Signal input terminal
Video input signal terminals have priority in the following order.
Caution
1 S-VIDEO input terminal 2 RCA jack input terminal
Even when the video signal is displayed, only an audio signal is output to RGB audio output
terminals.
Connection to the RGB signal terminal
1. Input / output signal
Analog 0.7Vp-p 75 Ω termination (Positive polarity)
Video signal
Horizontal sync signal TTL level (Positive/negative polarity)
Vertical sync signal TTL level (Positive/negative polarity)
Composite sync signal TTL level
200mVrms, 20k Ω below (MAX 3.0Vp-p)
Input
Audio signal
0 ∼ 200mVrms, 1k Ω
Output
2. Signal input / output terminal
1 Video signal (Red)
2 Video signal (Green)
3 Video signal (Blue)
4 N.C
5 N.C
6 Ground (for R)
7 Ground (for G)
8 Ground (for B)
Do not use RGB cable other than that specified.
Caution
Some RGB cable may not operate DDC (Disply Data Channel)
because there are not connect from pin No. & to pin No.#.
1.0Vp-p, 75 Ω termination
0.286Vp-p (burst signal), 75 Ω termination
1.0Vp-p, 75 Ω termination
200mVrms, 20 kΩ below (MAX 3.0Vp-p)
0~200mVrms, 1k Ω
Chrominance signal
Ground
S VIDEO input (Mini DIN4 pin)
9 N.C
10 Ground
11 N.C
12 DDC (Display Data Channel)
13 Horizontal/Composite sync signal
14 Vertical sync signal
15 DDC (Display Data Channel)
Luminance signal
Ground
D-sub 15pin shrink terminal (Female)
19