Preparing For Menu Operations; Checking Main Projector's Operating Status - Hitachi CP-X8150 User Manual

5. Setting input ports using menu

5.1 Preparing for menu operations

If Simple Stack without an RS-232C connection is used, press the button
corresponding to the port on the remote control or the
projector to select the port to which the cable is connected. For setting of
MONITOR OUT, refer to
This completes the setting.
If Intellectual Stack with the RS-232C connection is used, all settings or
modications related to Intellectual Stack menu operations must be performed on
the Main projector. The Main projector functions according to the input settings
for Intellectual Stack.

5.2 Checking Main projector's operating status

For Intellectual Stack, all settings or modications related to menu operations
must be performed on the Main projector. Before operating the menu for
Intellectual Stack, check if the Main projector is functioning.
1.
Press the
2.
If the MENU dialog as shown on the right appears on
the screen, the two projectors are operating in DUAL
mode and the Main projector is operating.
Go to 5.4 Setting the
If the dialog does not appear, LAMP MODE is set to ALTERNATE and either
the Main or Sub projector is operating. Go to next.
3.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
( Operating Guide
4.
Check the STACK MODE setting in the STACK menu.
- If MAIN is displayed, the Main projector is operating. Go to
menu. ( 27 )
- If SUB is displayed, the Main projector is turned off and the Sub projector is
operating. Go to
SETUP menu
button on the remote control.
27 )
menu. (
→ OPTION menu)
5.3 Starting up Main
in Operating Guide.
projector. (
25
button on the
5.4 Setting the
26 )