Setting For Input Port On Menu; Preparing Menu Operation; Checking Main Projector's Operating Status - Hitachi CP-X4021N User Manual

5. Setting for input port on menu

5.1 Preparing menu operation

If you use Simple Stack
that you connect the cables to, pressing
remote control or INPUT
setting of the MONITOR
Then, the setting is finished.
If you use Intellectual Stack
changing anything related to menu operation for
done on Main projector. So
setting on Intellectual

5.2 Checking Main projector's operating status

On Intellectual Stack, setting or changing related to menu operation requires to
be done on Main projector. Before starting menu operation for
check whether or not
1.
Press MENU button on the remote control.
2.
If MENU dialog as right appears on screen, it is
confirmed that the two projectors are working in
mode and Main
Go to
5.4 Setting on
If the dialog does not appear,
Main or Sub projector is working. Go to next.
3.
Using the ▲/▼/◄/► buttons, go down the menu tree as below.
ADVANCED MENU
> SERVICE >
> STACK
STACK menu will appear on screen.
(Operating Guide
4.
Check STACK MODE
- If MAIN is shown, it is confirmed that
Setting on menu.
- If SUB is shown, it is confirmed that
working. Go to
All manuals and user guides at all-guides.com
without RS-232C cable connection, select the input port
button on the control panel on both projectors. For
OUT, refer to
with RS-232C cable connection, the setting or
Main projector should be working for input source
Stack.
Main projector is working as below.
projector is surely working.
31 )
(
menu.
LAMP MODE
> OPTION
COMMUNICATION
→
OPTION menu).
setting in STACK
31 )
(
5.3 Starting Main
COMPUTER or VIDEO
 S ETUP menu in the
Intellectual Stack
DUAL
is set to ALTERNATE
menu.
Main projector is working. Go to
Main projector is turned off and
30
projector. ( )
29
button on the
Operating Guide.
requires to be
Intellectual Stack,
and either
5.4
Sub is