Table of Contents
Advertisement
Connecting and Setting Up
Connecting the Television
Connecting the unit to the aerial
Plug the aerial cable into the aerial socket
This highly digitized TV set provides optimum picture and
sound quality.
For this, the following conditions must be met:
Correctly functioning aerial system and connecting leads
with high screening factor (85 dB) between the TV set and
the aerial socket, and between the TV set and the video
recorder, respectively.
Avoid cable loops near the TV set.
Connecting the unit to the mains
Plug the mains cable into the wall socket.
Additional Information for Units sold in Great Britain
Units sold in GB are suitable for operation from a 240 V AC, 50 Hz mains
supply.
In case this appliance is supplied with a Safety Standard Approved mains
lead fitted with a non-rewireable 13 Amp mains plug which, if unsuitable
for your socket, should be cut off and an appropriate plug fitted by a
qualified electrician. The fuse and fuse holder must be removed from the
plug as accidental insertion of the redundant plug into a 13 Amp socket
is likely to cause an electrical hazard.
Note: The severed plug must be destroyed to avoid a possible shock
hazard should it be inserted into a 13 Amp socket elsewhere.
If it is necessary to change the fuse in the non-rewireable plug, the cor-
rect type and rating (5 Amp ASTA or BSI approved BS 1362) must be
used and the fuse cover must be refitted. If the fuse cover is lost or
damaged the lead and plug must not be used until a replacement is
obtained. Replacement fuse covers should be obtained from your dealer.
If a non-rewireable plug or a rewireable 13 Amp (BS 1363) plug is used,
it must be fitted with a 5 Amp ASTA or BSI approved BS 1362 fuse. If any
othe type of plug is used it must be protected by a 5 Amp fuse either in
the plug or at the distribution board.
Important:
The wires in the mains lead are coloured in accordance with the follow-
ing code:
BLUE
– NEUTRAL
BROWN
– LIVE
As the colours of the wires in the mains lead of your appliance may not
correspond with the coloured marking identifying the terminals in your
plug, proceed as follows:
Connect the BLUE coloured wire to plug terminal marked with the letter
"N" or coloured black.
Connect the BROWN coloured wire to the plug terminal marked with a
letter "L" or coloured red.
In no circumstance must any of the wires be connected to the terminal
marked with a letter "E", earth symbol
yellow.
Replacement mains lead can be obtained from your dealer.
Inserting the Battery into the Remote
Control Handset
Remove the battery compartment cover by pressing on the
catch and then removing the cover.
É
on the unit.
, coloured green or green and
Insert the battery supplied. Make sure it is inserted correctly
(note the markings in the battery compartment).
When the battery is dead, the following display appears on
the screen: "Battery Telepilot".
Dead batteries must be removed immediately.
We assume no responsibility for damage resulting from
battery leakage.
Dead batteries should be disposed of properly (environ-
mental protection).
Switching the Unit On and Off
Press the
¢
button on the television.
I O
If you do not use the televison for extended periods of time
(e.g., at night), press this button to turn the televison off.
This helps you to save energy.
4
Advertisement
Table of Contents
