Quickstart Guide; What You Need Before You Can Use Your Internet Radio - Grace Digital VICTORIA GDI-IRN1941 User Manual

QUICKSTART GUIDE

What you need before you can use your Internet Radio:


A broadband internet connection is required.

A wireless (Wi-Fi) modem or router connected to your broadband (cable or DSL) internet.
NOTE: IF your wireless (Wi-Fi) network is password protected (WEP or WPA), please obtain your
password before proceeding to Step 1. All passwords are UPPER and lower case sensitive.
Step 1: Plug the round jack from the power cord into the back of the radio and the other end into a wall
outlet. On the back of the radio turn the main power switch to "ON". The display should turn on within
approximately 4 seconds and flash a series of messages. The messages that are briefly displayed will
be 'Grace Digital Radio', 'Starting...' then 'Scanning'.
NOTE: If your radio does not automatically start scanning when plugged into power the 1
press the 'Power / Vol' dial on the front of the radio to turn your radio on and to view the main Internet
radio menu. Turn the 'Push/Sel' dial to the left or right until the word 'settings' is highlighted. Press the
'Push/Sel' dial inwards to select 'settings'. On the top of the next screen please select 'Network
Configurations' by pressing the 'Push/Sel' dial. (To go back to previous menus at any time press the
'back' button on the radio). On the top of the next screen please select 'Scan for Networks' by pressing
the 'Push/ Sel' dial inwards.
Step 2: The radio is now scanning for available Wi-Fi (wireless) network(s) in your area. After the
scanning process is complete, the radio will display the names (also referred to as SSID's) of one or
more wireless networks that are within range. Scroll the 'Push/Sel' dial to the left or right until the name
of your network (SSID) is highlighted. After you highlight your network, press the 'Push/Sel' dial inwards
to select your network.
NOTE: If your radio does not display the name of your wireless network please make sure you are
within range of your wireless network. If your network does not broadcast its SSID you can enter it in
manually in the 'enter network name' section of the settings / network config. menu.
Step 3: The display will now prompt you to enter in your network's key. This 'Key' is the same key
(password) you use to connect any wireless device (laptop, mobile phones, game console etc) to your
Wi-Fi (wireless) network. This key or password is also sometimes called a 'WEP' or 'WPA' password or
'code'. If you do not know your password, please contact the person or company that set up your Wi-Fi
(wireless) network to obtain your password.
NOTE: All passwords are UPPER and lower case sensitive. Thus letters must be entered correctly
using upper or lower case as was used to set the password originally. To enter in your password, scroll
the 'Push/Sel' dial to the right or left until the 1
center of the radio's display. Press the dial inward to select the 1
final letter or number is selected.
NOTE: If you make a mistake at anytime, press the 'back' button to erase the letter(s) or number(s) then
select the correct entry. After the final letter or number in your password is selected rotate the dial until
7
st
- 1 time set up
st
letter or number in your password is located in the
st
letter. Continue this process until the
st
time, please