Mb Intelligent Tweaker(M.i.t.) - Gigabyte GA-MA74GM-S2H User Manual

2-9

MB Intelligent Tweaker(M.I.T.)

HT Link Frequency
CPU Clock Ratio
Memory Controller Freq.
CPU Host Clock Control
x CPU Frequency (MHz)
PCIE Clock (MHz)
VGA Core Clock (MHz)
Set Memory Clock
x Memory Clock
DDR2 Voltage Control
CPU Voltage Control
Normal CPU Vcore
: Move Enter: Select
F5: Previous Values
Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory
and reduce the useful life of these components. This page is for advanced users only and we
recommend you not to alter the default settings to prevent system instability or other unex-
pected results. (Inadequately altering the settings may result in system's failure to boot. If this
occurs, clear the CMOS values and reset the board to default values.)
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto
200 MHz~1 GHz
CPU Clock Ratio
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the
CPU being used.
Memory Controller Freq.
Allows you to alter the memory controller frequency for the installed CPU. The adjustable range is
dependent on the CPU being used.
CPU Host Clock Control
Enables or disables the control of CPU host clock. Auto (default) allows BIOS to automatically
adjust the CPU host frequency. Manual allows the CPU Frequency (Mhz) item below to be
configurable. Note: If your system fails to boot after overclocking, please wait for 20 seconds to
allow for automated system reboot, or clear the CMOS values to reset the board to default values.
CPU Frequency (MHz)
Allows you to manually set the CPU host frequency.
Important It is highly recommended that the CPU frequency be set in accordance with the CPU
specifications.
(Note) This item is present only if you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
MB Intelligent Tweaker(M.I.T.)
(Note)
+/-/PU/PD: Value
F6: Fail-Safe Defaults
BIOS will automatically adjust the HT Link Frequency. (Default)
Sets HT Link Frequency to 200 MHz~1 GHz.
(Note)
[Auto]
[Auto]
[Auto] 1800Mhz
[Auto]
200
[Auto]
[400]
[Auto]
DDR 533
[Normal]
[Normal]
1.3500V
F10: Save
- 47 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup