Advertisement
4. Press the MCK's Display Matrix momentarily and the Display Matrix dot's will shine green. Now
Dark Fire is in the Green Bank.
5. Turn the MCK to the Peg position.
6. Press the MCK's Display Matrix, and hold it in the pressed state until the LED symbols E, A, D,
G, B and e shine red. At this point the Peg LED will be shining magenta.
7. Strum the string which will serve as the basis for your Reference Tuning until its LED turns
green, which confirms that your reference frequency has been measured and registered.
8. Now strum all strings, and the remaining LED symbols will behave as during a normal tuning
operation. Dark Fire will tune to the selected tuning with respect to your new reference pitch.
9. When tuning is complete, the string LEDs will turn off.
You can store your changed reference tuning as a custom alternate tuning preset. Push the MCK all
the way in, and perform the procedure described in Creating Custom Alternate Tuning Presets,
including the procedure for storing the tuning in a preset position.
Note: An alternative method to use a reference other than A=440Hz is to change Dark Fire's
calibration, as described in Setup Mode.
Advertisement
