Q-See QSDT8PCRP User Manual page 22

Q-See
1. Dwell Interval.
If users enable Auto Dwell function on the main interface page, users can set
the dwell time, in seconds, of a screen here.
2. Caption
There are four options, None, ID, Name, and ID/Name for users to select for
all the channels.
'None' means no title or name;
•
'ID' means camera numbers, i.e. 1, 2, 3 and so on;
•
'Name' means camera names, i.e. Cam1, Cam2 and so on;
•
'ID/Name' means both camera number and camera name, i.e. 1/Cam1,
•
2/Cam2 and so on.
3. Resolution
There is one resolution option, 320
channels.
4. Call Monitor
Users can connect another monitor to the card and select the display modes
here.
The following area is for your recording data storage area. Please see section
3.3.8.
SuperDVR shows all the available HDD partitions for users. Users can select
one or more of the partitions that will be used in sequence from top to bottom.
Please refer to section 3.3.8 to learn more about recycling records.
In the following area in the basic configuration page, users can input the
computer user name and password in the relative boxes. Then when
restarting the computer system, it will give access to the system with the user
name and password that was put in the boxes.
22
S u p e r D V R & 8 P C R P / 8 P C D P / 1 6 P C R P
2 44 for users to select for all the
×
Figure4-3 Record Data Storage Precept
Figure4-4 Computer System Reboot Setup
U s e r M a n u a l