Table of Contents
Advertisement
SETUP MENU
To Access SETUP Menu
Refer to the "Using On-Screen
Menus" section for details.
Before Using SETUP Menu
Connect arid turn ON all external
equipment, such as cable "IN decoder,
VCR, etc. before using any item on
the SETUP Menu.
IAUTO PROGRAM
CH. ADD/DEL
CH. LABELS
TUNING
BAND
AUTO TUNING
SOURCE
ID
CLOCK SET
CAPTIONS
Main Setup
Menu
5E, TUPI
I SOURCE ID
CLOCK SET
CAPTIONS
Setup Menu for Video
and S-Video
Sources
AUTO PROGRAM
Purpose
Finds all available
channels
and stores them in the memory of
the TV for use by CHANNEL
(CH) Up/Down.
Use AUTO
PROGRAM
only when you first install your TV,
or when you permanently
change the connections
to the TV.
For example,
when you replace the antenna with a cable-TV
system.
NOTE:
AUTO PROGRAM
can only be used with ANT/
CABLE
1 or 2 Source selection.
To Use AUTO
PROGRAM
1.
Press
ADJUST
(ADJ)
Left/Right
to start
Auto
Pro-
gram.
2.
Use AUTO
PROGRAM
independently
for each AN-
TENNA
or CABLE
signal
source
connected
to your
TV.
Select
one source
by using
the SOURCE
MENU
(ANT/CABLE
1 or 2) and
use AUTO
PROGRAM.
When
completed,
select
the
other
source
and
use
AUTO
PROGRAM
again.
CH. (Channel)
ADD/DEL
Purpose
Lets you add channels
to and remove channels
from the chan-
nel scan. In this way you can customize
the channels
that are
accessed through
CHANNEL
(CH) Up!Down.
NOTE:
CH. ADD/DEL
can only be used with ANT/CABLE
1 or 2 S_)urce selection.
To Add a Channel
to Scan Sequence
1.
Press
ADJUST
(ADJ)
Left/Right
to view the channel
add/delete
screen.
2.
Use
the number
buttons
on the remote
to enter
the
channel
or use ADJUST
(ADJ)
Left/Right
and
SE-
LECT
Up/Down
to move the highlight
to the channel
you wish to add.
3.
Add
the channel
by pressing
SOURCE
until
the dis-
play
shows
ADDED.
AUTO PROGRAM
CH.ADD/DEL
CH. LABELS
TUNINGBAN[)
AUTOTUNING
SOURCEID
CLOCKSET
CAPTIONS
1
I
START
,.___
J
Selecting
Auto Program
When Some Channels Are Not Found
AUTO PROGRAM finds only active channels and stores
them in the faw)rite channel memory. You can add channels to
those stored in memory by using CH. ADD!DEL.
_UTOPROGRAM
;H. ADD/DEL
j
[
CH. LABEL. _
TUNING BAND
AUTO TUNING
SOURCE ID
CLOCK SET
CAPTIONS
CH 15 AriD
Selecting
Ch. Add/Del
To Delete a Channel from Scan Sequence
1.
Press ADJUST
(ADJ) Left/Right
to view the channel
add!delete
screerL.
2.
Use the number
buttons
on the remote
to enter the
channel
or use ADJUST
(ADJ)
Left/Right
and SE-
LECT Up/Down
to move the highlight
to the channel
you wish to delete.
3.
Delete
the channel
by pressing
SOURCE
until
the
display shows DELETED.
(continued
on next page)
2_s6-o
8 _
1
Advertisement
Table of Contents
