Zenith Z50PX2D Installation And Operating Manual, Warranty page 9

introduction
=
When using the remote control, aim it at the remote control sensor on the TV.
TV
• Rotates the input mode between Antenna
_d Cable.
Selects the remote operating mode: TV,
DVD, VCR, AUDIO CABLE or ST8, _Iect
a mode other than TV, for the rem,3te to
operate an external device,
External input modes rotate in regular
sequence: Antenna_ CaMe, Video, Front
Video, Component 1-2, RGB-DTV (or
RGB-PC) and HDMI/DVl input sources,
(Video, Front Video, Component 1-2 input
sources are linked automatica[ly_ only ff
these are connected )
Brings up the main menu to the screen.
RATIO
Changes the asset ratio.
Clears aH on-screen displays and returns to
TV viewing from any menu,
Lets you select the amount of time before
your TV turns itseff off automatically,
Switches the sound on or eff.(Refer to p40)
EZ
Selects a factory preset picture mode
depending on the viewing environment.
When you watch the TV, information dis-
plays on top of the screen. Not available
in Component 1_2, RGB and HDMI/DVf
mode, (Refer to p39)
Scrolls the Favorffe channeis
Tunes to the recent channels
Freezes the currently-viewed picture
Main picture is frozen.
Installing Bakeries
• Open the battery compartment cover on the back side and install the batteries
matching correct polarity (+ w_th +_ =with _)
• Install two 1 5V AA batteries, Don't mix old or used ba_des with new ones, Close
cover_
Operating Guide 9