Zenith Z50PX2D Installation And Operating Manual, Warranty page 14

Installation
3, Analog and Digital TV signals provided on cable and antenna
f
RF Co_ial Wire (75 ohm)
Bronze Wire
CabFe TV Wall Turn clockw_e to tighten,
Jack RF Coaxial Wire (75 ohm)
Bronze Wire
- To improve the picture quaJity in a p_r signal area,
pEease purchase a signal amplifier and install pro_r[y.
• If the antenna needs to _ split for two TV's, ins_all a "2-
Way Signa_ Spritter" in the connections.
°ff the antenna is not installed properly, contact your _al-
et for assistance.
,i j
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV
- Use the iSM Method (on the Option menu) feature to avoid having a fix_ image remain on the screen for a long period of time,
If the 4:3 picture format is used; the fixed images on the si_s of the screen may remain visible on the screen
Connection Option 1
Set VCR ou_ut switch to channel 3 or 4 and
then tune the TV to the same channel number
Connection Option 2
1, Connect the audio and video cables from the
VCR's output jacks to the TV input jacks, as
shown in the figure,
When connecting the TV to VCR, match the
jack colors (Video = yellow, Audio Left = white,
and Audio Right = red).
If you conn_ an S-ViDEO output from VCR to
the S-V_DEO input_ the picture quality is
improved; compared to connecting a regular
VCR to the Video input
2, Unsert a vid_ tape into the VCR and press
PLAY on the VCR, (Refer to the VCR owner's
manual )
& Select the input source with using the
TVNIDEO button on the remote control Note
that this TV finds the connected inpt,_ sources
automatically for Video, Front Video and
Component 1-2 it is presumed that RG8 and
H DM I/DVI sou rces are connected,
Do not connect to both Video and
S-V[_o at the same t_me
[]
VCR Rear
!4 Plasma 7q/