Auto F'me Tune; Clock Set - Zenith SENTRY 2 SAR2035Y7 Operating Manual & Warranty

SETUP .MENU
AUTO FINE TUNE
Lets your TV compensate for variationsin broadcast and
cable-TV frequencies.
If you are havingdifficulty tuningchannels, the AUTO
FINE TUNE may have to be set manuallyto match your
viewing n eeds.
Before Using AUTO FINE TUNE
Connect and turn ON all external equipment, such as cable-
TV decoder, VCR, etc.
NOTE: AUTO FINE TUNE is not displayedwhile AUX
channel is being used.
f
AUTO CH. SEARCH
CH. ADD/DEL
TUNING BAND
-> AUTO FINE'IUNE
CLOCKSET
CAPTIONS
Selecting Auto Fine Tune
AUTO FINE
FIXED
PRESS ADJUST
KEY TO CHANGE
Auto Fine Tune Display
To Use AUTO FINE 2ffJNE
1. AUTO FINE TUNE display should be shown on the
TV if you followed the "Basic Menu Operation"
given in the "On-Screen Menus" section.
2.Press ADJUST (ADJ) Left/Right to select the
desired mode of operation, as follows:
• FIXED is used to receive "over-the-air" TV stations,
and with many cable TV systems.
• SEARCH is used only when the "IV must search to
find the frequency being received, such as when used
with certain VCRs and video game controllers.
When Some Channels Are Not Clear
If some channels are not clear, change the TUNING
BAND. You may have to try different AUTO FINE TUNE
and TUNING BAND settings until you get a consistently •
clear picture, channel-to-channeL Refer to the TUNING
BAND option for details.
CLOCK SET
Sets the clock in the TV to the correct time.
After the time has been set, the currenttime will appear on
the Channe!/Timedisplaywhenever the "IVis turned on,
the channelis changed, or ENTER (ENT) is pressed.
PowerFailure Note: The time will have to be reset if power
to the TV is interrupted.
AOTOCH.SEARC_
CH.ADD/DEL
TUNING BAND
AUTO FINE TUNE
-> CLOCK SET
CAPTIONS
Selecting Clock Set
CLOCKSET
PRESS NUMBERS
OR ADJUST KEYS
Clock Set Display
To Use CLOCK SET from Remote Control
1. CLOCK SET display should be shown on the TV if
you followed the "Basic Menu Operation" given in
the "On-Screen Menus" section.
2. Use the numbered buttons on the remote control to
enter the current time. Press ENTER (ENT) to start
the clock.
For example, to set the clock to 12:30, press 1, then
2, then 3; then 0; and then press ENTER (ENT). If
you enter an invalid time, such as 14:35 or 2:80, the
time will disappear and you can enter another time.
To Use CLOCKSET from Control Panel
1. CLOCK SET display should be shown on the TV if
you followed the "Basic Menu Operation" given in
the "On-Screen Menus" section.
2. Use ADJUST (ADJ) Left/Right to set thetime, and
then press ENTER (ENT) to start the clock.
2591_ 8 - 3