Yard-Man 26M Operator's Manual page 6

T_:_ X
f 1. For shippingpurposes,the chutedeflectoron your
discarded before
operating the moWer.
NOTE: Your mower
s shipped with the
handle in the higher
height position.
NOTE: Each end of
the lower handle must
be placed in the same
relative oosition.
IMPORTANT
This unit is shipped
without gasoline or oil
in the engine. Fill up
gasoline and oil as
instructed in the engine
operation section
BEFORE operating
your mower.
Step 1
Step 2
moweris held in an uprightpositionbya retainer.
Removethe retaineras follows:
a. Push chutedeflectorup towardsengine.Holding
deflectorin this position,removethe retainerand
discard.See Step 1.
b. Lowerthe chute deflectorcarefullykeepingyour
fingersout of the way.
,_ WARNING: The chute retainer
must be removed and discarded
before operating the mower.
.
Performthe followingsequencefor handlesetup:
a. Lift the upper handleup from foldedpositionA and
pull it to extendedpositionB followingthe arrowin
Step2. The handleshouldclickinto this position.
b. Makesurethe carriageboltis seatedproperly
in thehandle.Tightenwing nuts securingupper
handleto the lowerhandle
3. If satisfiedwith heightof handle,tightenwingnuts
at the endsof the lowerhandleshownin Step3. For
convenience of operating,youmay adjustthe handle
heightby removingthewing nuts shownin Step3 and
removingthe lowerhandle.
a. Positioneach handlebracketstud intothe top hole
in thelowerhandle.See Step3 inset.
b. Tightenthewing nuts.
4. Insertpost on cable ties into holesprovidedon the
lowerhandle.Pullcabletie tight and trim excess.See
Step4.
f
Step 3
Step 4
6